Sometimes I’m not so sure where my time goes, but I do know that I finally have a craft project to share! Now that we’ve had like two whole fall days in Austin, I decided it was time for a new scarf. I’m pretty bad at wrapping traditional scarves around my neck and looking fashionable, so I decided to make an infinity scarf, which is a loop scarf that you can typically wear as a single long loop or short double loops if it’s cold. It’s hard to mess up wearing a loop. There are a number of tutorials about sewing an infinity scarf. I read quite a few and relied on this video from Craft Gemini to show me the step where you have to join the two ends to form a loop. It can be a bit confusing if you don’t take your time. More on that later. My Supplies:

• 1.5 yards of knit fabric, pre-washed and ironed as much as possible
• Hand carved stamps (stamp blocks carved with a speed ball cutter)
• Fabric paint in a few colors
• Standard sewing stuff – matching thread, sewing machine, etc.

First I decided on a design using tear drop shapes, sketched them on my stamp blocks and carved three separate stamps so that I could use them in a variety of patterns.

Then, I tested them out on some paper to make sure they stamped well.

I cut my knit fabric in half, so that I had two pieces of fabric, 1.5 yards long by 24 inches wide. Because you fold the fabric in half length wise and sew, this gives a scarf about about 12 inches wide (minus seam allowances). I got a nice dark brownish/grayish knit fabric with a small weave.

I then used my stamp set and fabric paint to hand stamp a design down the middle of both pieces of fabric.

If you do this, make sure to put something under the fabric as you stamp, the paint will seep through in some places. The next step was sewing. The first step to make an infinity scarf is to fold the fabric length wise, with the correct side of the fabric (in my case, the stamped side) touching. Then pin along the whole length of the fabric, but leave four inches on each side not sewn so that you can connect the loop in a later step.

When it comes time to sew, make sure to backstitch a bit on both ends so that your seams are secure!

After the fabric is sewn lengthwise, the tricky part begins. Definitely view the video I mentioned above if you are unsure about these steps. First, turn the fabric so that the correct side is facing out (the way it should be at the end). Notice the four inches that aren’t sewn on either side. Position the fabric so that the seams match and there are no twists in the fabric.

Next, you have to pin the ends of the fabric together, which is what feels a bit tricky. This is the part where you actually join your scarf into a loop. You start with matching corners and keep the correct side of the fabric facing in so that it touches the entire time you are pinning. Continue to pin around in a circle until you hit the other corners. The extra four inches you left on each side of the scarf is what allows you to do this – the rest of the fabric ends up being contained in those 8 inches after you are done pinning.

Then, you sew. Start at one corner and go to the other. Make sure to backstitch at both ends.

When you’re done, you’ll flip that section of the scarf so that the right side is facing out for the entire section. You’ll have an eight inch section left to hand sew to complete the scarf.

Pin the opening closed using the same seam allowance you used on the rest of the scarf.

I used a slip stitch to close the seam, with help of a tutorial from Michelle patterns. Then, I positioned the scarf so that the seam was positioned in the back. Lastly, I wore the scarf around town. You can see the loop in the scarf on the left and the view of the scarf when it’s flattened out on the right. I’m quite happy with the finished product!